引用本文:SONG Zu hua.Determination of SO3 in Stationary Pollution Source[J].Environmental Monitoring and Forewarning,2019,11(2):34~37
【打印本页】   【HTML】   【下载PDF全文】   View/Add Comment  【EndNote】   【RefMan】   【BibTex】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 5674次   下载 1630 本文二维码信息
码上扫一扫!
分享到: 微信 更多
固定污染源废气中三氧化硫测试方法初探
宋祖华
江苏省南京环境监测中心,江苏 南京 210013
摘要:
建立了异丙醇吸收-分光光度法测试固定污染源中三氧化硫(SO3)的方法,分别连续9次测试低、中、高3个质量浓度的SO3烟气。测试结果表明,相对误差分别为7.5 %,-2.6 %和6.7 %,相对标准偏差分别为3.3 %,1.7%和4.1%,方法的准确度和精密度较好。方法检出限为0.1 mg/m3,测定下限为0.4 mg/m3。二氧化硫(SO2)、一氧化碳(CO)、氮氧化物(NOx)、硫化氢(H2S)、含湿量、烟尘等因素对方法的干扰较小,方法适用于现场测试。
关键词:  三氧化硫  固定污染源  分光光度法
DOI:
分类号:O659.3
文献标识码:B
基金项目:南京市环保科技基金资助项目(201710)
Determination of SO3 in Stationary Pollution Source
SONG Zu hua
Jiangsu Nanjing Environmental Monitoring Center, Nanjing, Jiangsu 210013, China
Abstract:
A method for determination of SO3 in stationary sources by isopropyl alcohol absorption spectrophotometry was established. The SO3 flue gas with low,medium and high massconcentration was tested 9 times in succession. The results showed the relative errors were 7.5%,-2.6% and 6.7% respectively, RSDs were 3.3 %,1.7% and 4.1%.The accuracy and precision of the method are good.The detection limit was 0.1 mg/m3 and the limit of quantitation was 0.4 mg/m3. The method shows slight interference from sulfur dioxide (SO2), carbon monoxide (CO), nitrogen oxides (NOx), hydrogen sulfide (H2S), moisture content, smoke and other factors. The method is suitable for field test.
Key words:  SO3  Stationary pollution source  Spectrophotometry