• 首页
  • 期刊简介
  • 编委会
  • 投稿须知
  • 留言板
  • 期刊订阅
  • 广告合作
  • 联系我们
  • English
引用本文:郑燕,徐江坤,杜祥君.环氧树脂生产废水常温常压下催化氧化处理方法研究[J].环境监控与预警,2011,3(04):51-53[点击复制]
.Study on Catalyzing and Oxidizing Wastewater from Production of Epoxy resin under Normal Temperature and Pressure[J].Environmental Monitoring and Forewarning,2011,3(04):51-53[点击复制]
【打印本页】      【下载PDF全文】   【查看/发表评论】  【下载PDF阅读器】  【关闭】
←前一篇|后一篇→ 过刊浏览    高级检索
本文已被:浏览 2113次   下载 323次 本文二维码信息
码上扫一扫!
环氧树脂生产废水常温常压下催化氧化处理方法研究
郑燕,徐江坤,杜祥君
0
字体:加大+|默认|缩小-
(南京博环环保有限公司,江苏 南京210052)
摘要:
采用常温常压催化氧化工艺处理环氧树脂生产废水,通过实验发现,采用南京博环环保有限公司开发的负载型催化剂,在常温常压,进水pH为3.5-5.5,氧化时间为0.5h的条件下,COD的去除率可达到85%。
关键词:  环氧树脂生产废水  常温常压催化氧化  负载型催化剂
DOI:
投稿时间:2010-05-17
基金项目:
Study on Catalyzing and Oxidizing Wastewater from Production of Epoxy resin under Normal Temperature and Pressure
()
Abstract:
The catalytic oxidation treatment of the wastewater from production of epoxy resin under normal temperature and pressure is studied. Using the carrying-catalyst developed by Nanjing Grand Environment Protection Co.,Ltd and adjusting the pH of wastewater between 3.5~5.5, the removal efficiency of the COD could reach 85% after 0.5 hours' reaction under normal temperature and pressure.
Key words:  epoxy resin wastewater  normal temperature and pressure catalyzing  carrying-catalyst


版权所有:《环境监控与预警》
主办: 地址:南京市凤凰西街241号 邮政编码:
电话: 电子邮箱:
技术支持:北京勤云科技发展有限公司